Installation to a wall or a fence
To install a wall mounted letter box you need: A drill, 6 mm drill bit for steel (+ a drill bit for brick), a vacuum cleaner, a screwdriver and a tape measure. Fastening screws (for wood) are included but extra anchors are needed if the wall is made of brick, stone, etc. If you are uncertain about the corrrect placement please contact your local postoffice prior the installation.
More measurement information for installation here.
Place the letterbox face down on a surface that will not scratch it.
There are 4 preformed markings for fixing holes on the back of the letterbox.
Using a 6-7 mm drill bit for steel ...
Drill out the holes with low speed and clean the holes and remove all the metal remnants. Be careful not to scrach the surface. We recommend using a vacuum cleaner to ensure all the small metal parts are removed from the holes, seams and bottom of the letterbox. Otherwise, metal remnants can, over time, start to rust.
Check the correct height of the aperature.
Fasten it from the inside. If the wall is made of brick mark the holes and drill them out and install anchors before fastening.
Write down and save the key code.